═══════════Frequently Asked Question═══════════

Author: Gourang

After swapping to manual brakes, I encountered another annoying problem known as
H A N D B R A K E !
As it turned out, finding the handbrake lever at 81 marks was a real hassle.
For some time, I carried wooden chocks under the wheels. L0L)
In the end, I somehow managed to source a handbrake from a Turica 90.
I installed it yesterday. More like welded it on :P
Literally welded it on, too lazy to drill or turn anything else :|
How it was installed
First, remove the driver's seat (4 bolts), then unscrew the armrest (4 bolts inside the armrest)

Next, remove the old cable which goes from the pedal to the body (there are 2 more fasteners holding the cable under the upholstery)
Then remove the driveshaft as you can't fit otherwise. Install the new cable in its original place on the body and underneath it on a bracket (everything fits snugly with bolts ON)

After that, install the handbrake lever itself. Above I said - just welded it on :D The distance is fine, nothing obstructs.

Left the stock armrest but fixed it up

+ also on the side where the handbrake is located.

Everything gets reattached and voila!
As if it had always been like this.)

All that's left is to tighten the handbrake from below (4-5 clicks) and tighten the driveshaft.